Where should clamps be connected to the PV module?

When the mechanical load pressure is ±2400Pa, Clamps should be connected to the module between 400 and 500mm from the edge of the module. This distance is from the module edge to the middle of the clamp. *NOTE: We need two or three support rails below the PV module to make sure the module have a good mechanical load performance.

Why should you install a solar panel bracket?

The purpose of installing the bracket is to better fix the solar panel. If there is a more convenient and feasible method to fix the solar panel. PVMars will definitely recommend it to you, and effective solutions are based on solar panels’ characteristics and your on-site installation environment.

How do I install a double glass PV module?

Insert the PV module into the clamp, and make sure the module edge touch to the EPDM closely and then tighten the nut with uniform torque values using a qualified torque wrench to ensure the double glass module is firmly secured. Trina suggests using M8 bolts to affix the double glass modules onto the clamp.

How to install Trina Solar module with frameless clamps?

Please consult with a Trina Solar engineer before installing with the frameless clamps. Clamps should be connected to the module between 300 and 400 mm from the edge of the module. This distance is from the module edge to the middle of the clamp. *Note: Need two support rails below the PV module to make sure the Mechanical load.

Which materials should be used to install photovoltaic modules?

JA Solar recommends that when installing modules at the seaside, stainless steel or aluminum materials should be used to contact the photovoltaic modules, and the installation parts should be well protected from corrosion. The tilt angle of the modules is measured between the surface of the modules and a horizontal ground surface.

Which Racking clamps should I use for Trina Solar racking?

For C structure steel type 1 racking, due to the amount of space inside the racking section, many choices are available including T-shape nuts. Please consult with a Trina Solar engineer before installing with the frameless clamps. Clamps should be connected to the module between 300 and 400 mm from the edge of the module.